![]() So if you want to discover all there is to know about Optical Instruments (automated and non-automated), then we are the best bet for you. We are the world’s largest supplier of Optical Instruments, and we offer Optical Instruments solutions that fit every budget. I thank You all in advance and wish You a great weekend and Happy Easter!ĭo you wish to make your Optical practice a success? Have you been looking for a reliable source for your Optical Machine at discounted rates? Search no more as you can get the Optical Instruments alongside service and support from I believe this software was included on a CD or floppy disk in the blue box accompanying the machine.ĭoes anyone have a copy of the OPSYS software for sale, or know of a website that can provide a download link? I spent a lot of time searching for this software on the internet, but it appears that it is quite old and it is not available anywhere for downloading. I also wish to ask if someone might have a copy of the Essilor OPSYS Software Suite, required in order to connect the Tracer to a PC via a COM / Serial interface. Is it possible that the machine had a restraining bolt fitted in order to prevent its parts moving doring transport? I could find no indications of such a bolt in the manual, does anyone know if this machine comes with such a bolt installed?Ĭould there be such a bolt fitted to the machine, that might cause the Lens Holder error? If so where is it located (a diagram would be great)? The Grinding Wheel test also fails, although the wheel spins properly. I also tried the steps described in the manual and when performing a diagnosis on the Edger, the Lens Holder test fails. The lens holder does in deed not move at all, the machine just makes a sound as if it tried to move the lens holder but it is stuck, and the lightbulb inside the lens edging chamber flickers. In the manual (attached image) it says that this is a Lens Holder movement error. However, the Edger does not start up properly, it displays an error message: Error 'A 03 %9'. The Tracer works perfectly, when performing an auto diagnosis all tests check OK. I have succesfully set up the machine and connected the Tracer and the Edger modules. I have just bought a second-hand Essilor Kappa CTD machine, manufactured in 2008. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |